I'm simple trying to run FTP passing the following parameters and not succeeding. Obviously we are not communicating very well. What I'm trying to figure out is why running the same command in VisualCron would not connect while it does in Windows task scheduler.Ĭ:\Transfers>FTP -i -s:C:\transfers\tjwfrom.txtĢ30-Last unsuccessful login: Thu Feb 9 11:44: on ftp from ::ffff:999.999.999.99Ģ30-Last login: Fri Jan 29 06:40: on ftp from xxxxxxxftp_remote As you can see, I'm not even getting an ftp>connected response. For the most part, what you see in the second error is what I'm getting for all of my jobs. I understand what you are saying, the problem is the first error I listed was caused by essentially the same task as the second (I know it is a different error, but the second error is all I can get now). VisualCron job results running same command file: This is the most common result I've seen in the jobs.Ĭ:\Transfers>FTP -i -s:C:\transfers\testfrom.txtĢ20 phi FTP server (Version 4.1 Fri Aug 8 15:14:) ready.Ģ57 "/xxxxxxx/qdx5.3/integrator/phprgen/ftpdata/mdt_adt" is current directory.ĭrwxrwsrwx 2 hci staff 4096 Jan 29 06:40 archiveįtp: 75 bytes received in 0.00Seconds 75000.00Kbytes/sec. Ok, did what you asked and here are the results. "FTP -i -s:C:\transfers\EEP\fromtext.txt" where fromtext.txt contains:ġ50 Opening data connection for xxx027.dat (1656324 bytes).įtp: 1657648 bytes received in 1.73Seconds 955.97Kbytes/sec.ġ50 Opening data connection for xxx027.dat.įtp: 1657648 bytes sent in 1.72Seconds 964.87Kbytes/sec. (Although no failure messages are shown by VisualCron) cmd files that contain command line FTP commands? All of my jobs fail to successfully run the FTP commands. Are there known problems or limitation to running.
0 Comments
Leave a Reply. |